ALPHA, the new cross fiber helmet from SUOMY studied in detail for internal comfort technology and security for the end user.
TRICARBOCO shell , produced in two sizes (M and L), fabric made from a mixture of Kevlar, carbon and fiber bonded resin.
Inner polystyrene in three sizes (S M and L) for maximum comfort with variable density.
Approvals ECE 22-05
INNER POLYSTYRENE is produced in three sizes to ensure the best fit. This characteristic allows energy to be absorbed gradually and progressively created by the impact
even if most of the energy created by the impact absorbed by the outer shell due to its deformation The role of polystyrene is decisive for the absorption of residual energy.
Different densities of polystyrene allow us to optimize the mechanical properties of the shell/polystyrene.
D-Ring Retention SYSTEM was developed and patented by Suomy. Insert the free side of the strap into the rings. Pull the end until the belt is pressed tightly against the jaw.
After this operation it will be impossible to remove the helmet. Make sure that by taking it from behind and turning it to the front it cannot be removed and is fixed on the head. If the helmet tends to come off or rotate re-tighten the belt until the required pressure is achieved and repeat the test. If, after repeating the test, you are unable to effectively tighten the fastening system do not use a helmet.
Only after checking the correct tension of the belt, fix the free end , fixing it with an automatic pin to the Automatic pin fastener, you only need to fix the free end of the belt so that it does not dangle while driving. Fixing the release button does not guarantee the correct position and correct fastening of the helmet: the correct fixation of the strap must be checked exclusively in accordance with the points above.
To unlock the fastening system release the automatic clasp button and pull the tab. to loosen the closure. Pull the free end of the belt out of the D-rings.
Use the clamp only to remove the helmet ! Never release this latch while driving.
Researched so that the inner polystyrene works together with the vents installed on the body. The channels ensure perfect circulation of internal air and at the same time a rapid flow of external air thanks to rear ventilation.